![]() ![]() There is one especially nifty feature, though: You can set up a “Duress PIN,” which you can use if someone is threatening you to disable the alarm, just like in the movies. SimpliSafe recommends keeping at least 10 feet between the keypad and the base station, but I set up mine. This is all part of the goal of keeping things as simple as possible. Simplisafe key fob manual Something is wrong. Additionally, if you need to remove the strips, it will be much more difficult as you would need to pull them up. After 2 or 3 cycles of this, the pad finally locked in, and I havent had an issue since. ![]() The only solution i found was to make sure and leave the batteries out for 5 minutes. The way you have it now, I am unsure how the Keypad can hold properly. Same basic issue, where the keypad would work, but then shut down and not power up. SimpliSafe gives you the option of naming each sensor (by choosing from preconfigured room names or by typing one in through the keypad) to help you keep things organized, but otherwise there are few configurability options. If not, your Keypad bracket (that attaches to the wall) should have the pull tabs on the adhesive strips on the bottom. Just follow the “Add device” instructions on the keypad (the screen can be physically depressed on each of its four sides, making navigation very intuitive), and then press a button on the sensor to pair it. If you need additional standard sensors, they’re quite affordable: just $15 for door/window sensors and $30 for motion sensors. A huge variety of additional devices are available, including a new and more capable indoor camera ($140), and an outdoor camera ($190), a glass-break sensor ($35), and a freeze sensor ($30). In addition to the keypad, the starter kit includes the SimpliSafe base station (which contains the siren and provides voice commands, countdown beeps, and door open chirps), three door/window sensors, a motion sensor, one indoor camera, and a key fob remote control. SimpliSafe’s keypad walks you through the basics of setup. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |